Cannone da 149/40 modello 35

The Cannone da 149/40 was a heavy gun which served with Italy during World War II. It was intended to replace the obsolete Cannone da 149/35 A, but the small numbers produced prevented that. By 1940 orders had been placed for 590, but only 51 were in service at the end of September 1941. Weapons captured by the Germans after the Italian surrender in 1943 were put into service as the 15 cm K 408(i). Ansaldo produced a batch of twelve for the Germans in April 1944.

Cannone da 149/40
A battery of 149/40 guns.
TypeHeavy Gun
Place of originKingdom of Italy
Service history
In service1940-1945
Used by Kingdom of Italy
 Nazi Germany
WarsWorld War II
Production history
DesignerAnsaldo
ManufacturerAnsaldo
Produced1940-44
Specifications
Mass11,340 kilograms (25,000 lb)
Barrel length6.036 metres (19 ft 10 in) L/38.7

Shell45.96 kilograms (101.3 lb)
Caliber149.1 mm (5.87 in)
CarriageSplit trail
Elevation0° to +45°
Traverse60°
Rate of fire1-2 rpm
Muzzle velocity800 m/s (2,625 ft/s)
Maximum firing range23,700 metres (25,900 yd)

It was a good design despite the odd decision to use trail spade plates that had to be pounded into the ground to anchor the gun in place. Normally it was broken down into two loads for transport, but it could be further broken down into four loads for mountainous terrain.

References

  • Chamberlain, Peter & Gander, Terry. Heavy Artillery. New York: Arco, 1975 ISBN 0-668-03898-5


This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.