Mean free path

In physics, the mean free path is the average distance travelled by a moving particle (such as an atom, a molecule, a photon) between successive impacts (collisions),[1] which modifies its direction or energy or other particle properties.

Scattering theory

Slab of target

Imagine a beam of particles being shot through a target, and consider an infinitesimally thin slab of the target (see the figure).[2] The atoms (or particles) that might stop a beam particle are shown in red. The magnitude of the mean free path depends on the characteristics of the system. Assuming that all the target particles are at rest but only the beam particle is moving, that gives an expression for the mean free path:

where is the mean free path, n is the number of target particles per unit volume, and σ is the effective cross-sectional area for collision.

The area of the slab is L2, and its volume is L2dx. The typical number of stopping atoms in the slab is the concentration n times the volume, i.e., n L2dx. The probability that a beam particle will be stopped in that slab is the net area of the stopping atoms divided by the total area of the slab:

where σ is the area (or, more formally, the "scattering cross-section") of one atom.

The drop in beam intensity equals the incoming beam intensity multiplied by the probability of the particle being stopped within the slab:

This is an ordinary differential equation:

whose solution is known as Beer-Lambert law and has the form , where x is the distance traveled by the beam through the target, and I0 is the beam intensity before it entered the target; is called the mean free path because it equals the mean distance traveled by a beam particle before being stopped. To see this, note that the probability that a particle is absorbed between x and x + dx is given by

Thus the expectation value (or average, or simply mean) of x is

The fraction of particles that are not stopped (attenuated) by the slab is called transmission , where x is equal to the thickness of the slab x = dx.

Kinetic theory of gases

In the kinetic theory of gases, the mean free path of a particle, such as a molecule, is the average distance the particle travels between collisions with other moving particles. The derivation above assumed the target particles to be at rest, therefore in reality, the formula holds for a beam particle with a high speed relative to the velocities of an ensemble of identical particles with random locations. In that case, the motions of target particles are comparatively negligible, hence the relative velocity .

If, on the other hand, the beam particle is part of an established equilibrium with identical particles, then the square of relative velocity is:

In equilibrium, and are random and uncorrelated, therefore , and the relative speed is

This means that the number of collisions is times the number with stationary targets. Therefore, the following relationship applies:[3]

and using (ideal gas law) and (effective cross-sectional area for spherical particles with radius ), it may be shown that the mean free path is[4]

where kB is the Boltzmann constant.

In practice, the diameter of gas molecules is not well defined. In fact, the kinetic diameter of a molecule is defined in terms of the mean free path. Typically, gas molecules do not behave like hard spheres, but rather attract each other at larger distances and repel each other at shorter distances, as can be described with a Lennard-Jones potential. One way to deal with such "soft" molecules is to use the Lennard-Jones σ parameter as the diameter. Another way is to assume a hard-sphere gas that has the same viscosity as the actual gas being considered. This leads to a mean free path [5]

where m is the molecular mass, and μ is the viscosity. This expression can be put into the following convenient form

with being the universal gas constant and the molecular weight. These different definitions of the molecular diameter can lead to slightly different values of the mean free path.

The following table lists some typical values for air at different pressures at room temperature.

Vacuum range Pressure in hPa (mbar) Pressure in mmHg (Torr) number density (Molecules / cm3) number density (Molecules / m3) Mean free path
Ambient pressure 1013 759.8 2.7 × 1019 2.7 × 1025 68 nm[6]
Low vacuum 300 – 1 220 – 8×10−1 1019 – 1016 1025 – 1022 0.1 – 100 μm
Medium vacuum 1 – 10−3 8×10−1 – 8×10−4 1016 – 1013 1022 – 1019 0.1 – 100 mm
High vacuum 10−3 – 10−7 8×10−4 – 8×10−8 1013 – 109 1019 – 1015 10 cm – 1 km
Ultra-high vacuum 10−7 – 10−12 8×10−8 – 8×10−13 109 – 104 1015 – 1010 1 km – 105 km
Extremely high vacuum <10−12 <8×10−13 <104 <1010 >105 km

In other fields

Radiography

Mean free path for photons in energy range from 1 keV to 20 MeV for elements with Z = 1 to 100.[7] The discontinuities are due to low density of gas elements. Six bands correspond to neighborhoods of six noble gases. Also shown are locations of absorption edges.

In gamma-ray radiography the mean free path of a pencil beam of mono-energetic photons is the average distance a photon travels between collisions with atoms of the target material. It depends on the material and the energy of the photons:

where μ is the linear attenuation coefficient, μ/ρ is the mass attenuation coefficient and ρ is the density of the material. The mass attenuation coefficient can be looked up or calculated for any material and energy combination using the National Institute of Standards and Technology (NIST) databases.[8][9]

In X-ray radiography the calculation of the mean free path is more complicated, because photons are not mono-energetic, but have some distribution of energies called a spectrum. As photons move through the target material, they are attenuated with probabilities depending on their energy, as a result their distribution changes in process called spectrum hardening. Because of spectrum hardening, the mean free path of the X-ray spectrum changes with distance.

Sometimes one measures the thickness of a material in the number of mean free paths. Material with the thickness of one mean free path will attenuate to 37% (1/e) of photons. This concept is closely related to half-value layer (HVL): a material with a thickness of one HVL will attenuate 50% of photons. A standard x-ray image is a transmission image, an image with negative logarithm of its intensities is sometimes called a number of mean free paths image.

Electronics

In macroscopic charge transport, the mean free path of a charge carrier in a metal is proportional to the electrical mobility , a value directly related to electrical conductivity, that is:

where q is the charge, is the mean free time, m* is the effective mass, and vF is the Fermi velocity of the charge carrier. The Fermi velocity can easily be derived from the Fermi energy via the non-relativistic kinetic energy equation. In thin films, however, the film thickness can be smaller than the predicted mean free path, making surface scattering much more noticeable, effectively increasing the resistivity.

Electron mobility through a medium with dimensions smaller than the mean free path of electrons occurs through ballistic conduction or ballistic transport. In such scenarios electrons alter their motion only in collisions with conductor walls.

Optics

If one takes a suspension of non-light-absorbing particles of diameter d with a volume fraction Φ, the mean free path of the photons is:[10]

where Qs is the scattering efficiency factor. Qs can be evaluated numerically for spherical particles using Mie theory.

Acoustics

In an otherwise empty cavity, the mean free path of a single particle bouncing off the walls is:

where V is the volume of the cavity, S is the total inside surface area of the cavity, and F is a constant related to the shape of the cavity. For most simple cavity shapes, F is approximately 4.[11]

This relation is used in the derivation of the Sabine equation in acoustics, using a geometrical approximation of sound propagation.[12]

Nuclear and particle physics

In particle physics the concept of the mean free path is not commonly used, being replaced by the similar concept of attenuation length. In particular, for high-energy photons, which mostly interact by electron–positron pair production, the radiation length is used much like the mean free path in radiography.

Independent-particle models in nuclear physics require the undisturbed orbiting of nucleons within the nucleus before they interact with other nucleons.[13]

The effective mean free path of a nucleon in nuclear matter must be somewhat larger than the nuclear dimensions in order to allow the use of the independent particle model. This requirement seems to be in contradiction to the assumptions made in the theory ... We are facing here one of the fundamental problems of nuclear structure physics which has yet to be solved.

John Markus Blatt and Victor Weisskopf, Theoretical nuclear physics (1952)[14]

See also

References

  1. Brünglinghaus, Marion. "Mean free path". European Nuclear Society. Archived from the original on 2011-11-05. Retrieved 2011-11-08.
  2. Chen, Frank F. (1984). Introduction to Plasma Physics and Controlled Fusion (1st ed.). Plenum Press. p. 156. ISBN 0-306-41332-9.
  3. S. Chapman and T. G. Cowling, The mathematical theory of non-uniform gases, 3rd. edition, Cambridge University Press, 1990, ISBN 0-521-40844-X, p. 88.
  4. "Mean Free Path, Molecular Collisions". Hyperphysics.phy-astr.gsu.edu. Retrieved 2011-11-08.
  5. Vincenti, W. G. and Kruger, C. H. (1965). Introduction to physical gas dynamics. Krieger Publishing Company. p. 414.CS1 maint: multiple names: authors list (link)
  6. Jennings, S (1988). "The mean free path in air". Journal of Aerosol Science. 19 (2): 159. Bibcode:1988JAerS..19..159J. doi:10.1016/0021-8502(88)90219-4.
  7. Based on data from "NIST: Note - X-Ray Form Factor and Attenuation Databases". Physics.nist.gov. 1998-03-10. Retrieved 2011-11-08.
  8. Hubbell, J. H.; Seltzer, S. M. "Tables of X-Ray Mass Attenuation Coefficients and Mass Energy-Absorption Coefficients". National Institute of Standards and Technology. Retrieved 19 September 2007.
  9. Berger, M. J.; Hubbell, J. H.; Seltzer, S. M.; Chang, J.; Coursey, J. S.; Sukumar, R.; Zucker, D. S. "XCOM: Photon Cross Sections Database". National Institute of Standards and Technology (NIST). Retrieved 19 September 2007.
  10. Mengual, O.; Meunier, G.; Cayré, I.; Puech, K.; Snabre, P. (1999). "TURBISCAN MA 2000: multiple light scattering measurement for concentrated emulsion and suspension instability analysis". Talanta. 50 (2): 445–56. doi:10.1016/S0039-9140(99)00129-0. PMID 18967735.
  11. Young, Robert W. (July 1959). "Sabine Reverberation Equation and Sound Power Calculations". The Journal of the Acoustical Society of America. 31 (7): 918. Bibcode:1959ASAJ...31..912Y. doi:10.1121/1.1907816.
  12. Davis, D. and Patronis, E. "Sound System Engineering" (1997) Focal Press, ISBN 0-240-80305-1 p. 173.
  13. Cook, Norman D. (2010). "The Mean Free Path of Nucleons in Nuclei". Models of the Atomic Nucleus (2 ed.). Heidelberg: Springer. p. 324. ISBN 978-3-642-14736-4.
  14. Blatt, John M.; Weisskopf, Victor F. (1979). Theoretical Nuclear Physics. doi:10.1007/978-1-4612-9959-2. ISBN 978-1-4612-9961-5.
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.