Water table
The water table is the upper surface of the zone of saturation. The zone of saturation is where the pores and fractures of the ground are saturated with water.[1]
The water table is the surface where the water pressure head is equal to the atmospheric pressure (where gauge pressure = 0). It may be visualized as the "surface" of the subsurface materials that are saturated with groundwater in a given vicinity.[2]
The groundwater may be from precipitation or from groundwater flowing into the aquifer. In areas with sufficient precipitation, water infiltrates through pore spaces in the soil, passing through the unsaturated zone. At increasing depths, water fills in more of the pore spaces in the soils, until a zone of saturation is reached. Below the water table, in the phreatic zone (zone of saturation), layers of permeable rock that yield groundwater are called aquifers. In less permeable soils, such as tight bedrock formations and historic lakebed deposits, the water table may be more difficult to define.
The water table should not be confused with the water level in a deeper well. If a deeper aquifer has a lower permeable unit that confines the upward flow, then the water level in this aquifer may rise to a level that is greater or less than the elevation of the actual water table. The elevation of the water in this deeper well is dependent upon the pressure in the deeper aquifer and is referred to as the potentiometric surface, not the water table.[2]
Form
The water table may vary due to seasonal changes such as precipitation and evapotranspiration. In undeveloped regions with permeable soils that receive sufficient amounts of precipitation, the water table typically slopes toward rivers that act to drain the groundwater away and release the pressure in the aquifer. Springs, rivers, lakes and oases occur when the water table reaches the surface. Groundwater entering rivers and lakes accounts for the base-flow water levels in water bodies.[3]
Surface topography
Within an aquifer, the water table is rarely horizontal, but reflects the surface relief due to the capillary effect[4] (capillary fringe) in soils, sediments and other porous media. In the aquifer, groundwater flows from points of higher pressure to points of lower pressure, and the direction of groundwater flow typically has both a horizontal and a vertical component. The slope of the water table is known as the hydraulic gradient, which depends on the rate at which water is added to and removed from the aquifer and the permeability of the material. The water table does not always mimic the topography due to variations in the underlying geological structure (e.g., folded, faulted, fractured bedrock).
Perched water tables
A perched water table (or perched aquifer) is an aquifer that occurs above the regional water table. This occurs when there is an impermeable layer of rock or sediment (aquiclude) or relatively impermeable layer (aquitard) above the main water table/aquifer but below the land surface. If a perched aquifer's flow intersects the surface, at a valley wall, for example, the water is discharged as a spring.
Fluctuations
Tidal fluctuations
On low-lying oceanic islands with porous soil, freshwater tends to collect in lenticular pools on top of the denser seawater intruding from the sides of the islands. Such an island's freshwater lens, and thus the water table, rises and falls with the tides.
Seasonal fluctuations
In some regions, for example, Great Britain or California, winter precipitation is often higher than summer precipitation and so the groundwater storage is not fully recharged in summer. Consequently, the water table is lower during the summer. This disparity between the level of the winter and summer water table is known as the "zone of intermittent saturation", wherein the water table will fluctuate in response to climatic conditions.
Long-term fluctuations
Fossil water is groundwater that has remained in an aquifer for several millennia and occurs mainly in deserts. It is non-renewable by present-day rainfall due to its depth below the surface, and any extraction causes a permanent change in the water table in such regions.
Effects on crop yield
Most crops need a water table at a minimum depth because at shallower depths the crop suffers a yield decline.[7] For some important food and fiber crops a classification was made:[8]
| Crop and location | DWT tolerance | Classification | Explanation |
|---|---|---|---|
| Wheat, Nile Delta, Egypt | 45 | Very tolerant | Resists shallow water tables |
| Sugar cane, Australia | 60 | Tolerant | The water table should be deeper than 60 cm |
| Banana, Surinam | 70 | Slightly sensitive | Yield declines at water tables < than 70 cm deep |
| Cotton, Nile Delta | 90 | Sensitive | Cotton needs dry feet, water table should be deep |
- (Where DWT = depth to water table in centimetres)
See also
- Artesian aquifer – A confined aquifer containing groundwater under positive pressure
- Groundwater recharge – Groundwater that recharges an aquifer
- Hydrogeology – The study of the distribution and movement of groundwater
- Watertable control
References
- "What is the Water Table?". imnh.isu.edu. Retrieved 2016-11-25.
- Freeze, R. Allan; Cherry, John A. (1979). Groundwater. Englewood Cliffs, NJ: Prentice-Hall. ISBN 9780133653120. OCLC 252025686.
- Winter, Thomas C; Harvey, Judson W (1998). "Ground Water and Surface Water A Single Resource - U.S. Geological Survey Circular 1139" (PDF). Retrieved 25 August 2018.
- "Water table". www.tititudorancea.com. Retrieved 2018-08-24.
- Rudd, A.V. and C.W Chardon 1977. The effects of drainage on cane yields as measured by water table height in the Machnade Mill area. In: Proceedings of the 44th Conference of the Queensland Society of Sugar Cane Technology, Australia.
- Software for partial regression with horizontal segment
- K.J.Lenselink et al. Crop tolerance to shallow water tables. Online:
- Nijland, H.J. and S. El Guindy 1984. Crop yields, soil salinity and water table depth in the Nile Delta. In: ILRI Annual Report 1983, Wageningen, The Netherlands, pp. 19–29. Online: